Additional information
| Weight | 1.25 lbs |
|---|---|
| Dimensions | 14 × 4 × 4 in |
$210.00
Starter Kit for Reservoirs up to 20 Gallons
- 1 ea Stainless Steel Split Tube Carrier
(with SS attachment lanyard and split ring) - 3 ea WaterMag Refills (individually packaged)
- Installation Instructions
Everything you need for an initial system dry up
in a small hydraulic or lubrication reservoir
Open one WaterMag refill and place it in the carrier. Attach the lanyard to the large hole near the retention screw in the carrier. Secure the opposite end of the cable to an appropriate location outside the tank. Drop the carrier through any opening greater than 1.125″ ID (28mm) and close up the reservoir. Three days later replace the WaterMag refill to complete an initial system dry up. Use the third refill three days later to start your routine maintenance cycle. Routine maintenance intervals will then be based on the rate of water ingress.
(To speed initial dry up or extend maintenance intervals, use the split ring to daisy chain 2 or more Carriers in a single reservoir.)
Each WaterMag adsorbs approximately 2 oz (60ml) of dissolved, emulsified, or free water.
(WaterMags will not react with mineral oils, synthetic oils, or additives.)
Stainless Steel Split Tube Carrier Specifications:
- 13.875” (347mm) Long
- 1.125“ (28mm) Outside Diameter
- 51″ (1295mm) Stainless Retention Lanyard
(with 2 eyelets)
Drop in—Dry out—It’s just that simple!
